User Manual Q&AAnswer
Oct 07, 2025 - 03:23 PM
To properly install the Panasonic ET-MDNDP10C Interface Board for DisplayPort 2 Input to your projector, follow these steps as outlined in the instruction manual:
1. **Turn off the power:** Always turn off the power of the projector before installing or removing the Interface Board. Make sure to follow the procedure described in the Operating Instructions of your projector when turning off the power.
2. **Prevent static electricity damage:** Do not touch the connector section of the Interface Board directly with your hands. To prevent static electricity damage, remove the static electricity in your body by touching the surrounding metal, etc. beforehand.
3. **Avoid injuries:** Take care not to get injured when installing or removing the Interface Board. Hands may be injured by the opening of the blank slot of the projector or the edge of the bracket of the Interface Board.
4. **Installation steps:**
a. Remove the slot cover.
b. Remove the four screws fixing the slot cover of the projector.
c. Install the Interface Board to the projector by aligning the guide groove of the Interface Board with the salient of the slot and inserting the bracket firmly all the way in.
d. Fix the Interface Board by tightening and fixing it with the four screws removed in step b.
5. **Additional tips:**
- Always attach the slot cover on the blank slot.
- Store the removed Interface Board inside an antistatic bag.
By following these steps carefully, you can successfully install the Panasonic ET-MDNDP10C Interface Board for DisplayPort 2 Input to your projector without any issues.
Add New Comment