User Manual Q&AAnswer
Oct 07, 2025 - 10:33 AM
To associate your VFC300 WiFi Data Logger to your WiFi access point, follow these steps as outlined in the installation guide:
1. **Charge the Data Logger:** Ensure the VFC300/350 data loggers are fully charged for at least 8 hours before installation.
2. **Condition the Probe:** Place the probe with the glycol bottle in the fridge/freezer for 2-3 hours to condition it.
3. **Perform Factory Reset:** Hold down the button on the front of the data logger for 20 seconds until you see "FArSFArS" to perform a factory reset.
4. **Use the Software:** Utilize the provided software to associate the logger to your WiFi access point.
5. **Check Signal Strength:** Ensure the signal strength is 5 or above when positioning the logger where it will be mounted.
6. **Determine Power Source:** Decide on the power source and route the power cable to the data logger.
7. **Install Wall Mounting Bracket:** Once the logger location is identified, install the wall mounting bracket after cleaning the area with alcohol.
8. **Route the Cable:** Use zip ties and cable tie mounts to route the cable to the logger without cinching them down yet.
9. **Secure Cables:** Once all cables are routed, cinch down the zip ties to secure them in place.
10. **Associate Logger to Cloud Account:** Sign into your Cloud account, click on "Set-Up Device," and follow the on-screen instructions to connect the data logger to your network.
By following these steps, you can successfully associate your VFC300 WiFi Data Logger to your WiFi access point for efficient monitoring of temperatures.
Add New Comment