User Manual Q&AAnswer
Oct 05, 2025 - 04:04 PM
If the LED Flying saucer is not working properly after assembly, here are some troubleshooting steps you can take based on the information provided in the manual:
1. **Check Soldering Connections:** Ensure that all components are soldered correctly onto the circuit board. Check for any loose connections, cold solder joints, or solder bridges between adjacent points.
2. **Verify Polarity:** Double-check the polarity of components such as diodes (D1), LEDs (LED1-LED12), and the battery connector. Make sure they are oriented correctly according to the markings on the circuit board and the assembly instructions.
3. **Inspect Components:** Verify that all components are placed in the correct positions and orientations as specified in the assembly instructions. Pay special attention to components marked with "!" for polarity.
4. **Battery Check:** Ensure that the batteries (3×AA) are inserted correctly into the battery connector with the correct polarity (red-positive, black-negative). Replace the batteries if they are depleted or not making proper contact.
5. **Switches Functionality:** Test the functionality of the three switches (S1, S2, S3) to ensure they are working correctly. Check if they are making proper contact when activated.
6. **Component Damage:** Inspect components for any signs of damage or defects that may have occurred during assembly. Replace any damaged components if necessary.
7. **Power Supply:** Verify that the power supply (4.5VDC) is reaching the circuit board. Use a multimeter to check for voltage at key points in the circuit.
8. **Contact Manufacturer:** If the issue persists after troubleshooting, contact AVT SPV or refer to their website for further support or possible replacement of faulty components.
By following these troubleshooting steps and referring to the assembly instructions, you should be able to identify and resolve any issues with the LED Flying saucer kit not working properly.
Add New Comment