User Manual Q&AAnswer
Oct 05, 2025 - 02:36 PM
To reset the Digital Control Unit for Thermal Solar Systems, follow these steps as per the instruction manual:
1. Locate the reset key labeled as `RESET' located behind the removable door.
2. Press the `RESET' key using your finger (DO NOT USE PINS OR NEEDLES) to reset the device.
3. After pressing the `RESET' key, the control unit will reset, and any errors or anomalies will be cleared.
4. The device will go through a diagnostic process to verify correct operation, indicated by the red LED flashing three times.
5. If there are no issues detected during the diagnostic process, the red LED will remain on, indicating normal operation.
By following these steps, you can successfully reset the Digital Control Unit for Thermal Solar Systems.
Add New Comment