User Manual Q&AAnswer
Oct 05, 2025 - 10:49 AM
To select and change the flash patterns on the Cell2 Omni View Dual L-Bracket 9 LED Corner Warning Lighthead, follow these steps:
1. **Flash Pattern Selection:**
- Each warning mode can select and save one flash pattern.
- While activating a warning mode, momentarily apply the YELLOW wire to +VDC:
- Once to move to the next pattern.
- Quickly three times to revert to the default flash pattern (FP#1 or FP#18).
2. **Flash Pattern Options:**
- The manual provides a list of flash patterns ranging from Double to Steady Scene (Cruise Mode).
3. **Low Power Operation:**
- To enable Low Power Operation, apply the WHITE wire to +VDC while the warning mode is activated.
- To disable Low Power Operation, momentarily apply the YELLOW wire to +VDC once to force High Power Operation and permanently disable Low Power Operation. Re-activate Low Power Operation by applying the YELLOW wire to +VDC again.
4. **Factory Default Settings Reset:**
- Power up the unit by applying +VDC to RED and YELLOW wires simultaneously to enter SETTING MODE.
- Remove the YELLOW wire from +VDC and then apply it to +VDC again for more than 5 seconds to reset to factory default settings.
By following these instructions, users can easily select, change, save, and reset the flash patterns on the Cell2 Omni View Dual L-Bracket 9 LED Corner Warning Lighthead according to their preferences and requirements.
Add New Comment