User Manual Q&AAnswer
Oct 05, 2025 - 09:46 AM
To synchronize multiple cell2 ES3 3-LED Narrow Profile Lightheads and change their flash patterns, follow these steps based on the provided instruction manual:
1. **Synchronization:**
- Connect the YELLOW wires of all heads together for synchronization. All heads should be set to the same pattern.
- For Simultaneous or Alternating Flash:
- Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode. The lighthead will display short flashes.
- Single flash = Group1
- Double flash = Group2
- Heads in the same Group flash together, with Group1 alternating with Group2 heads.
2. **Changing Flash Patterns:**
- Momentarily apply +VDC to the YELLOW wire:
- Once for the next pattern
- Quickly three times to reset to FP#1
- Note: The unit may not be factory-set at FP#1.
3. **Flash Pattern Codes:**
- Double [2Hz]: 9
- Double [SAE]: 2
- Single [2Hz]: 10
- Triple [SAE]: 3
- Triple [2Hz]: 11
- Quad [SAE]: 4
- Quad [2Hz]: 12
- Quint [SAE]: 5
- Random: 13
- Ultra [SAE]: 6
- Steady: 14
- Single-Quad: 7
- Single [SAE, CA13]: 15
- Single H/L: 8
- Mega: 16
- Single-Triple-Quint
4. **Bracket Options:**
- Universal Bracket (Angle-Adjustable)
- L-Bracket (Front)
- L-Bracket (Rear)
By following these steps and codes, you can synchronize multiple lightheads and customize their flash patterns according to your preferences.
Add New Comment