User Manual Q&AAnswer
Oct 03, 2025 - 04:45 PM
To set the module address for the aspar RS485 8 Analogue Universal Inputs Module, you can use the switches on the module itself. The module address can be set with the switches in the range of 0 to 31. Addresses from 128 to 255 can be set via RS485 or USB.
Here is a breakdown of how to set the module address using the switches:
- **Switch 1:** Module address +1
- **Switch 2:** Module address +2
- **Switch 3:** Module address +4
- **Switch 4:** Module address +8
- **Switch 5:** Module address +16
For example, to set the module address to 3, you would turn on switches 1 and 2.
Remember that after setting the module address using the switches, you may need to power cycle the module for the changes to take effect.
If you need to set an address above 31, you can do so via RS485 or USB communication as specified in the manual.
For further details and specific instructions, please refer to the "Setting Module Address in RS485 Modbus Network" section of the user manual provided for the aspar RS485 8 Analogue Universal Inputs Module.
Add New Comment