User Manual Q&AAnswer
Oct 01, 2025 - 11:09 AM
To program a chase sequence on the qtx DMX-192 192 Channel DMX Controller, follow these steps as outlined in the user manual:
1. **Creating a Chase:**
- Press and hold the Program button until the LED blinks.
- Press the relevant Chase button you wish to program.
- Change Bank if necessary to locate the desired scene.
- Select the Scene to insert.
- Press the MIDI Add button to store.
- Repeat steps 3 to 5 to add additional steps to the chase. Up to 240 steps can be recorded.
- Hold the Program button to save the completed chase.
2. **Running a Chase:**
- Press the relevant Chase button then press the AUTO del button.
- Adjust the Chase speed by tapping the Tap Sync display button twice at your chosen rate.
- Note: The time between 2 taps will set the chase speed (up to a max. of 10 minutes).
3. **Checking a Chase:**
- Press and hold the Program button until the LED blinks.
- Select the desired Chase button.
- Press the Tap Sync display button to switch the display to step view.
- Use Bank up or Bank down buttons to review each scene in the chase.
4. **Editing a Chase (copying a Bank into a Chase):**
- Press and hold the Program button until the LED blinks.
- Select the desired Chase button.
- Select the Bank to be copied using the Bank up or Bank down buttons.
- Press Music/Bank copy button to prepare the copy.
- Press MIDI Add button to copy. All LEDs will blink to confirm.
By following these steps, you can successfully program and run a chase sequence on the qtx DMX-192 192 Channel DMX Controller.
Add New Comment