User Manual Q&AAnswer
Oct 01, 2025 - 09:34 AM
To set up and configure the FORENEX FR-E2Sxy Ethernet to Serial interface, follow these steps:
1. **Initial Setup:**
- Connect the E2S board to your host PC directly or to a LAN.
- Ensure that the IP address of your host PC is in the same segment as the default IP address of the E2S board (192.168.0.3).
- Access the E2S board's web interface by opening a web browser. Use "admin" as both the username and password to log in.
2. **Basic Configuration:**
- In the web interface, you can change serial settings (such as baud rate and flow control) and Ethernet settings.
- Note that if DHCP Client is disabled, you need to set the static IP address and subnet mask manually.
3. **Security Settings:**
- The web interface allows you to change login accounts for the web server and Telnet server.
- Be cautious when setting the Accessible IP list, as the E2S board can only be configured by the specified IP addresses.
4. **Ethernet Application Examples:**
- Depending on your setup (direct connection or via LAN), configure the E2S board accordingly.
- Ensure that the IP settings of the E2S board and your host device are compatible for communication.
- Follow the specific instructions for Client or Server mode operation based on your requirements.
5. **Appendices:**
- Appendix A provides details on Flow Control Packet over Ethernet for certain models.
- Appendix B explains communication with SPI devices over Ethernet for specific models.
By following these steps and referring to the detailed instructions in the manual, you can successfully set up and configure the FORENEX FR-E2Sxy Ethernet to Serial interface for your specific application needs.
Add New Comment