How do I set up and start using the PCE-HT 112 Data Logger? (PCE-HT 112 Data Logger User Manual)

Answer

manuals.plus

Sep 30, 2025 - 04:31 PM


To set up and start using the PCE-HT 112 Data Logger, follow these steps based on the user manual:



1. **Switch on the device**: The data logger will turn on when batteries are inserted into the device.



2. **Switch on the display**: Press the key for three seconds to switch on the display.



3. **Switching the time/date**: Press the key to switch between date, time, and marker view.



4. **Start data recording**: Press the key for three seconds to begin data recording.



5. **Stop data recording**: To stop recording, press the key for three seconds. Recording also stops when the memory is full or batteries are low.



6. **Display minimum, maximum, and average measured values**: Once data is saved, use the key to display MIN, MAX, and average values. If no data is recorded, you can view upper and lower alarm limits.



7. **Deactivate the audible alarm**: Acknowledge alarms by pressing any key when the meter beeps.



8. **Set markers**: In recording mode, press the key to switch to marker view. To set a marker, press the key for three seconds to save it.



9. **Read out data**: Connect the data logger to a PC and start the software to read out data. The USB icon will appear on the display when connected.



Remember to refer to the user manual for detailed instructions and safety precautions. If you encounter any issues or have further questions, contact PCE Instruments using the provided contact information at the end of the manual.