User Manual Q&AAnswer
Sep 29, 2025 - 02:13 PM
If you are facing issues with no image output when using the Microtech HDMI Extender Over Network Cable, here are some troubleshooting steps you can follow based on the user manual:
1. **Adjust RX "RESET" button:** If there is no image output, try adjusting the "RESET" button on the RX (RJ45 to HDMI receiver) to see if it resolves the issue.
2. **RX "LINK" LED flashing all the time:** Ensure that the network cable connection follows the standard of 568B. Check if the TX (HDMI to RJ45 sender) has HDMI signal input. You can also try resetting either the TX or RX to see if that helps.
3. **RX "LINK" LED lights on all the time but no image output:** Adjust the RX "RESET" button. Make sure the HDMI cable is properly connected to the TV. Reconnect the network cable and power on the receiver again.
By following these troubleshooting steps, you should be able to address the issue of no image output when using the Microtech HDMI Extender Over Network Cable. If the problem persists, refer to the user manual for further guidance or contact customer support for assistance.
Add New Comment