User Manual Q&AAnswer
Sep 26, 2025 - 02:13 PM
To set up and configure the ETAG-TECH ET1010C-S Electronic Shelf Label for use in your store, follow these steps as outlined in the user manual:
1. **Distribution Network Setup:**
- Connect to the distribution network using SSID: ETAG_TFT_CONFIG and password: etagtech2022.
- Ensure that the distribution network address is accurate and can be accessed via telnet.
- Configure Hotspots with the following parameters: Equipment name: ETAG_TFT_CONFIG, AP Frequency band: 2.4G.
2. **Install eRetail3.1 Server Program:**
- Install the eRetail3.1 server program in advance and ensure that the TFT. Api interface address can be pinged.
3. **Power On and Register Color Screens:**
- Power on the color screens in batches for distribution network registration.
- After successful distribution network setup, view the [Store Management] section in the Digital Signage Management interface.
4. **Device Status Check:**
- Check the service status by verifying if the Api service of digital signage is online or by connecting via telnet to 192.168.4.26 4001.
5. **Troubleshooting Power Failure:**
- In case of power failure of a color screen, view the [Store Management] - [Digital Signage Management] to identify the registered screens and address any power issues promptly.
6. **FCC Compliance and Safety:**
- Follow FCC guidelines for operation and installation to ensure compliance and safety standards are met.
By following these steps and guidelines provided in the user manual, you can effectively set up and configure the ETAG-TECH ET1010C-S Electronic Shelf Label for real-time product information updates in your store.
Add New Comment