User Manual Q&AAnswer
Sep 26, 2025 - 09:16 AM
To connect the SpaceLogic KNX USB Interface DIN Rail to your PC for programming and diagnostics, follow these steps:
1. **Required Equipment:** You will need a USB cable (Type C) to establish the connection between the device and your PC.
2. **Locate USB Connector:** The SpaceLogic KNX USB Interface DIN Rail features a USB connector (Type C) labeled as "C" in the device manual.
3. **Connect USB Cable:** Plug one end of the USB cable into the USB connector on the SpaceLogic KNX USB Interface DIN Rail (Type C) and the other end into a USB port on your PC.
4. **Power Supply:** Ensure that the device is receiving power via the KNX bus and the USB interface. The bus power supply should be less than 3 mA, and the USB power supply should be 5V with a current draw of less than 15 mA.
5. **LED Indicators:** Monitor the USB LED (multicolor) and KNX LED (multicolor) on the device to check for proper connection and communication status.
6. **Software Setup:** Install any necessary software or drivers on your PC to enable communication with the SpaceLogic KNX USB Interface DIN Rail.
7. **Programming and Diagnostics:** Once the connection is established and the device is powered on, you can use your PC to address, program, and diagnose bus components connected to the KNX network.
By following these steps and referring to the device manual for additional information, you can successfully connect the SpaceLogic KNX USB Interface DIN Rail to your PC for programming and diagnostics.
Add New Comment