User Manual Q&AAnswer
Sep 25, 2025 - 03:08 PM
To synchronize multiple Cell2 B16 Cruise BB units for simultaneous or alternating flashing patterns, follow these steps as outlined in the user manual:
1. **Connect YELLOW wires:** Connect the YELLOW wires of all units together for synchronization. Ensure that all units are set to the same flash pattern.
2. **Enter Setting Mode:** Power up the units with YELLOW and RED wires simultaneously. Then, remove the YELLOW wire from +VDC. The beacon will display short flashes:
- Single flash = Group 1
- Double flash = Group 2
3. **Change Groups:** Momentarily apply the YELLOW wire to +VDC to change groups. Lightheads of the same group will flash together, while lightheads of different groups will flash alternately.
4. **Save and Exit Setting Mode:** Once the desired synchronization is achieved, save and exit the setting mode by disconnecting all power.
By following these steps, you can synchronize multiple Cell2 B16 Cruise BB units for simultaneous or alternating flashing patterns.
Add New Comment