User Manual Q&AAnswer
Sep 25, 2025 - 01:20 PM
According to the user manual, here are the steps to connect the LED strip to the controller and driver:
1. Unroll the LED strip and ensure all components are complete.
2. Connect the LED strip to the controller and driver following the wiring diagram provided in the manual.
3. Light up the LED strip to check if all parts are in good condition.
4. Make sure to use the alcohol prep pad to clean the installation surface before sticking the LED strip. The surface should be clean, dry, and smooth to ensure proper adhesion.
5. Cut the LED strip to the required length. Note that once the strip is cut, both ends will need separate power sources and connectors (not included in the package).
6. Peel off the back tape and carefully paste the strip onto the surface.
7. Fix the receiver controller using 3M tape and use clips to secure the LED strip in place.
By following these steps and referring to the wiring diagram, you should be able to successfully connect the LED strip to the controller and driver for proper functionality.
Add New Comment