User Manual Q&AAnswer
Sep 24, 2025 - 04:31 PM
To reset the Hager TYFS120 IP Gateway to its factory default settings, follow these steps as outlined in the user manual:
1. Separate the KNX Bus connector from the device.
2. Press and hold down the KNX programming button.
3. Reconnect the KNX Bus connector of the device.
4. Keep the KNX programming button pressed for at least another 6 seconds.
Upon successful reset, all LEDs on the device will flash briefly, indicating that the device has been reset to its factory default settings.
Please note that resetting the device to its factory settings should only be done when necessary, as it will erase any custom configurations or settings that have been applied to the device.
Add New Comment