How do I properly install the GE current HORT145 Arize Life2 LED Lighting System using the provided instructions? (GE current HORT145 LED Lighting System Installation Guide)

Answer

manuals.plus

Sep 24, 2025 - 04:13 PM


To properly install the GE current HORT145 Arize Life2 LED Lighting System, follow these steps outlined in the installation guide:



1. **Prepare Electrical Wiring:** Ensure you have the necessary tools and components required for installation, such as wire stripper/cutter, screwdriver, cordless drill with driver bit, mounting clips, self-tapping screws, wire connectors, end caps, and optional accessories like jumper cables and cable clamps.



2. **Single Luminaire Installation (Method 1):**

   - Mount the luminaire using Current's standard or slim mounting clips on a flat surface.

   - Secure the luminaire in the mounting clips with the male connector oriented towards the electrical supply.

   - Insert an end cap into the female connector for protection.



3. **Directly Interconnected Luminaires (Method 2):**

   - Ensure proper spacing between luminaires for optimal performance.

   - Secure each luminaire in the mounting clips with the male connector oriented towards the electrical supply.

   - Connect luminaires using jumper cables if needed.

   - Secure cables with optional cable clamps.

   - Insert end caps into the female connector on the last luminaire in the run.



4. **Wiring Connections (Method 3):**

   - Connect the leader cable to the first luminaire in the run.

   - Inside the junction box, connect the AC supply source wires to the leader cable wires using wire nuts.

   - Cap the dimming wires if not using 0-10V dimming; follow specific instructions if dimming will be used.

   - Ensure proper cable routing and protection as per guidelines.



5. **Replacement Instructions (Method 4):**

   - Disconnect the connector on both sides of the luminaire.

   - Unscrew the mounting clips to remove the luminaire.

   - Gently pry the luminaire out of the mounting clips.

   - Follow installation steps to insert a new luminaire.



6. **Troubleshooting:** If LED fixtures are not illuminated, check connections, circuit breakers, and plug connectors. Ensure proper connections and secure cables.



By following these installation steps and guidelines provided in the manual, you can effectively set up the GE current HORT145 Arize Life2 LED Lighting System for your intended use.