User Manual Q&AAnswer
Sep 23, 2025 - 03:44 PM
To properly install the router on the MEEC TOOLS 022532 Router Table, follow these steps as outlined in the instruction manual:
1. **Fitting the Clamps:**
- Put the carriage bolts through the holes in the worktop.
- Place the clamps on the carriage bolts on the underside of the worktop with the hooks on the sides of the clamps turned to the underside of the worktop.
- Fix the clamps in place with the supplied washers and nuts.
2. **Installation of Router on the Product:**
- Turn the product upside down.
- Put the router in the recess on the underside of the worktop and fit the clamps round it.
- Lock the router in place by tightening the nuts with an 8 mm spanner.
- Check that the router is firmly in place.
3. **Fitting and Removing Bits:**
- Place the product on its side.
- Fit or remove a bit on the router according to the instructions for the router.
- Stand the product upright again.
4. **Fitting Dust Extraction Adapter:**
- Put the dust extraction adapter in the dust extraction port behind the fence.
- Connect the product to the dust extraction device by connecting a hose to the dust extraction adapter.
By following these steps, you can properly install the router on the MEEC TOOLS 022532 Router Table for safe and efficient use.
Add New Comment