User Manual Q&AAnswer
Sep 21, 2025 - 03:56 PM
To set the module address for the aspar SDM-16O 16 Digital Outputs Expansion Module, you can follow the instructions provided in the user manual:
1. **Switch Configuration:** The module address is set using a series of switches on the module itself. Each switch corresponds to a specific value that contributes to the final address setting.
2. **Switch Positions:** The switches are labeled SW1 to SW7, with each switch representing a binary value that contributes to the address calculation. Switch SW1 represents +1, SW2 represents +2, SW3 represents +4, and so on up to SW7 representing +64.
3. **Address Calculation:** To determine the module address, you need to add up the values represented by the switches that are in the "on" position. For example, if switches 1, 3, and 5 are in the "on" position, the calculation would be: Address = 1 + 4 + 16 = 21.
4. **Setting the Address:** Adjust the switches on the module to the desired binary values that correspond to the address you want to set. Ensure that only the necessary switches are in the "on" position based on your desired address.
5. **Verification:** Once you have set the switches to the desired configuration, verify the calculated address based on the positions of the switches to ensure it matches your intended address setting.
6. **Alternative Address Setting:** Addresses from 128 to 255 can also be set via RS485 or USB communication methods.
By following these steps and correctly configuring the switches on the module, you can effectively set the module address for the aspar SDM-16O 16 Digital Outputs Expansion Module, enabling proper communication within your system.
Add New Comment