How do I properly set the channel, group, and mode for my camera and flashes? (Godox XProN TTL Wireless Flash Trigger Nikon Cameras User Manual)

Answer

manuals.plus

Sep 09, 2025 - 12:45 AM


To properly set up your Godox XProN TTL Wireless Flash Trigger for Nikon Cameras, follow these steps:



1. **Channel Setting:**

   - Long press the  button to choose the channel value.

   - Turn the select dial to select the appropriate channel.

   - Press the  button to confirm the channel setting.

   - Ensure that both the transmitter and receiver are set to the same channel before usage.



2. **Wireless ID Settings:**

   - Change the wireless channels and wireless ID to avoid interference. Set the wireless IDs and channels of the master unit and the slave to the same value.

   - Press the

button to enter C.Fn ID. - Choose a figure from 01 to 99 to set the wireless ID. For current Godox flashes, set the ID to OFF. 3. **Mode Setting:** - Short press the button to change the mode of the current group. - Set the groups to five groups (A-E) or 16 groups (0-F) depending on your setup. - Long press the button for 2 seconds to lock the screen. Long press again to unlock. 4. **Output Value Settings:** - Adjust the power output value for each group in M mode. - Press the group button to choose the group and turn the select dial to change the power output value. - Confirm the setting by pressing the button. 5. **Flash Exposure Compensation Settings:** - Adjust the flash exposure compensation for each group in TTL mode. - Press the group button to choose the group and turn the select dial to change the FEC value. - Confirm the setting by pressing the button. By following these steps and referring to the detailed instructions in the user manual, you should be able to properly set up your Godox XProN TTL Wireless Flash Trigger for Nikon Cameras for seamless operation with your camera and flashes.

Source: https://manuals.plus/godox/xpron-ttl-...