User Manual Q&AAnswer
Sep 04, 2025 - 06:23 AM
According to the instruction manual for the IOTA ILBHI CP10 HE SD LC Emergency LED Driver, here are the steps to verify the correct operation of the emergency LED driver:
1. **Normal Mode Verification:**
- When A.C. power is present, the A.C. Driver should operate the LED Module as intended.
- The TCTS (Three Color Test Switch) will be lit, indicating that the battery is being charged.
2. **Emergency Mode Verification:**
- In the event of an A.C. power failure, the ILBHI CP HE SD should automatically switch to Emergency Mode.
- The LED Module should illuminate at a reduced output level for a minimum of 90 minutes.
- When A.C. power is restored, the system should switch back to Normal Mode and resume battery charging.
3. **Manual Verification:**
- Press and hold the TCTS button for two seconds. The pilot light should blink.
- Within five seconds, the LED Module should operate at a reduced light output, indicating that the emergency mode is functioning correctly.
- The test mode runs for 60 seconds. To exit the test mode earlier, press and hold the TCTS button for two seconds.
4. **Indicator Lights:**
- The TCTS light should be on when the unit is charging the battery.
- During testing, the TCTS status indicator light should be GREEN to initiate a manual test.
By following these steps and observing the indicated lights and behaviors, you can ensure that the emergency LED driver is operating correctly as per the manufacturer's instructions.
Add New Comment