User Manual Q&AAnswer
Aug 29, 2025 - 10:53 PM
To commission the THORN BORIS Gen2 Sensor using the remote control, follow these steps as outlined in the manual:
1. **Sensor Commissioning:**
- Press the button on the remote control to display the stored parameters.
- Press the "enter" button to enter the setting condition. The parameter LEDs on the remote control will flash to indicate selection.
- Use the navigation buttons to select the desired settings.
- Press "ok" to confirm and save all settings.
- Aim the remote control at the target sensor and press the upload button to send the new parameters. The luminaire will flash to confirm the settings received.
2. **Sensor Commissioning using Modes:**
- Press the button on the remote control to display the stored parameters.
- Use the navigation buttons to select new parameters if required.
- Press the "enter" button to confirm the parameters set and update the selected mode.
- Press the upload button to upload the parameters to the sensor.
3. **Default Mode Settings:**
- The manual provides default mode settings for different scenarios, including brightness, sensitivity, hold time, stand-by time, and stand-by dim level for both MWS and PIR modes.
4. **Additional Warnings and Instructions:**
- The manual also includes warnings about removing batteries if the remote control will not be used for 30 days, warm-up times for the sensors, precautions regarding reflected HF waves, and installation instructions to be carried out by qualified electricians.
By following these steps and referring to the provided default mode settings, users can effectively commission and configure the THORN BORIS Gen2 Sensor using the remote control.
Add New Comment