User Manual Q&AAnswer
Aug 28, 2025 - 05:31 AM
1. **Power Supply:** The Tridonic XC G3 CWM 30 DA2 Control Module with Switch is powered via the DALI-2 signal line, with a supply voltage range of 9.5 – 22.5 V. Ensure that the device is not connected to the mains power supply.
2. **Momentary Switches:** Connect up to 4 momentary switches or relays directly to the device. These switches should have potential free contacts and must not be connected to the mains power supply.
3. **Wiring:** Follow the wiring diagram provided in the installation guide to correctly connect the momentary switches to the control module. Each device output should have only one momentary switch connected.
4. **Safety:** Before handling the device, make sure to switch off the power supply. Installation should only be carried out by specialist staff with the necessary skills and knowledge of safety regulations.
5. **DALI-2 Network:** Multiple devices can be used on the same DALI-2 network, allowing for a flexible and scalable setup.
6. **Areas of Application:** The device is designed for specific applications and should only be used in dry, clean environments where access is restricted to tools.
By following these guidelines and referring to the provided wiring diagram, users can correctly wire the Tridonic XC G3 CWM 30 DA2 Control Module with Switch for safe and efficient operation.
Add New Comment