User Manual Q&AAnswer
Aug 23, 2025 - 08:20 PM
According to the user manual, here is how you can change the settings on the Ustellar UT88107W-CW-US 50W Smart Outdoor LED Security Light using the remote controller:
1. **Manual Mode:** You can control the security light to be constantly ON or OFF using this mode.
2. **Sensor Mode:**
- **MODE1 (PIR mode):** The light will turn on at 100% brightness when people pass through the sensor area and turn off when they leave.
- **MODE2 (DIM mode):** The light will turn on at 100% brightness when motion is detected, and then dim to 20% brightness after people leave.
- **MODE3 (D2D mode):** The light will turn on at 100% brightness at night and automatically turn off in the morning. Motion detection is disabled in this mode.
3. **HOLD TIME:** Set the duration for which the light remains on after motion is detected. Options include 10 seconds, 1 minute, 5 minutes, or 10 minutes.
4. **SENS:** Adjust the sensor sensitivity for motion detection. Choose between LOW (low sensitivity) and HIGH (high sensitivity).
5. **LUX:** Set the luminance detection to trigger the light. Choose between DAY (light triggers during the day) and NIGHT (light triggers only at night).
**Additional Tips:**
- The remote controller has a memory function, so it will start in your last chosen mode and settings.
- Ensure there are no obstacles between the remote controller and the light for optimal signal response.
- If the remote controller stops working, try replacing the battery following the instructions provided. If issues persist, contact the seller for assistance.
By following these steps, users can easily customize the settings of the Ustellar UT88107W-CW-US 50W Smart Outdoor LED Security Light to meet their specific requirements.
Add New Comment