User Manual Q&AAnswer
Aug 23, 2025 - 06:59 PM
To pair the LED Controller with an RF Remote, follow these steps as per the instruction manual:
1. **Activate the RF Remote:** Short press the ON button on the RF remote to activate it.
2. **Select a Zone:** If the RF remote is a multi-zone remote, select a zone by short pressing the corresponding zone number.
3. **Put the LED Controller in RF Pairing Mode:** Short press the "Prog." button on the LED controller 3 times or reset the power 3 times to set it to RF pairing mode.
4. **Pair the Remote with the LED Controller:** Immediately touch the color wheel or short press any other button on the remote except the ON/OFF button.
5. **Successful Pairing:** The LED lights connected to the controller will blink once to indicate successful pairing.
**Additional Information:** If you need to delete the pairing with the RF remote, press and hold the "Prog." button on the LED controller for over 3 seconds until the connected LED lights blink, indicating that the pairing has been successfully deleted
Add New Comment