User Manual Q&AAnswer
Aug 23, 2025 - 05:22 AM
To ensure you are using the Back Biowrap correctly, follow these steps:
1. **Set Up:** Make sure the 4” Snap Cables are attached to the snaps on the outside of the Biowrap. Connect the blue connectors at the other end of each cable to your BioWave Leadwire Cable.
2. **Skin Preparation:** Clean your skin with soap and water where the silver fabric will touch your skin. Apply a pea-sized amount of BioWrap Conductive Cream to these areas.
3. **Application:** Position the silver fabric rectangles on the inside of the Biowrap over the painful areas on your low back. Wrap the left side around your stomach, then the right side, and secure with the Velcro closure. Tighten the BioWrap for a comfortable compression over your lower back.
4. **Treatment:** Plug the leadwire cable into the BioWave device, turn it on, and adjust the intensity using the PLUS (+) button until you feel a strong but comfortable sensation. Increase intensity as needed during the 30-minute treatment.
5. **Troubleshooting:** If you encounter a connection error, ensure the Biowrap is properly connected. If you forgot to apply the conductive cream, clean your skin, apply the cream, and reattach the Biowrap. If the treatment feels weak, adjust the compression or apply more conductive cream.
By following these steps and referring to the user guide for detailed instructions, you can effectively use the Back Biowrap for pain relief and recovery.
Add New Comment