User Manual Q&AAnswer
Aug 20, 2025 - 08:11 PM
To set up different heating schedules for the three zones using the EPH CONTROLS R37-RF 3 Zone RF Programmer, follow these steps:
1. **Accessing Programming Mode:**
- Lower the cover on the front of the programmer.
- Move the selector switch to the PROG SET position to change the program setting.
2. **Setting Heating Schedules for Each Zone:**
- Use the or buttons to select the day, month, year, hour, and minute for the desired heating schedule.
- Press OK after each selection to confirm.
- Use the or buttons to select the desired program type (5/2D, 7D, or 24H) and press OK to confirm.
3. **Activating Frost Protection:**
- Move the selector switch to the RUN position.
- Press both the and buttons simultaneously for 5 seconds to enter selection mode.
- Use the or buttons to turn On or Off the frost protection function.
- Press OK to confirm.
- Adjust the desired frost protection setpoint using the or buttons and press OK to confirm.
4. **Saving and Running the Program:**
- Once all settings are configured for each zone, move the selector switch to the RUN position to activate the programmed heating schedules.
By following these steps, you can effectively set up different heating schedules for each zone using the EPH CONTROLS R37-RF 3 Zone RF Programmer. For further assistance or troubleshooting, refer to the instruction manual or contact EPH Controls technical support.
Add New Comment