User Manual Q&AAnswer
Aug 18, 2025 - 10:09 PM
To program a new sensor or replace a missing sensor in the Oricom TPS10-4I Real Time Tyre Pressure Monitoring System, follow these steps:
1. Press the "" button 5 times to enter programming mode. The display will beep once to indicate it's in programming mode.
2. Select the desired tyre position by following these steps:
- Hold the “ ” button and press the “ ” button once to select the interface. (Interface sequence: tow vehicle → Axle A of Trailer → Axle B of Trailer → Spare tyre)
- Press the “ ” button to select the desired tyre.
3. Deflate the corresponding tyre slightly.
4. The corresponding tyre data will be shown on the display. Press the “ ” button once to save the data.
5. Press the “ ” button to select the next sensor position.
6. After programming all sensors, press the “ “ button for 4 seconds to exit the programming mode.
Make sure to follow these steps carefully to ensure the new sensor is correctly programmed and integrated into the tyre pressure monitoring system.
Add New Comment