User Manual Q&AAnswer
Aug 14, 2025 - 07:05 PM
To program scenes on the AUDIBAX Control 8 192 Channel DMX Controller, follow these steps:
1. Press the PROGRAM button for 3 seconds to enter PROGRAM mode. The corresponding LED will flash, indicating that the unit is in PROGRAM mode.
2. Press the SCENE button (or buttons if you want to program several devices simultaneously) to select the scenes you want to program.
3. Adjust the faders to set the desired settings for each scene.
4. Once you have programmed the scenes, you can exit PROGRAM mode by pressing the PROGRAM button again. The LED will turn off.
To activate and play the programmed scenes:
1. Select a bank by pressing the UP or DOWN buttons. There are 30 banks available, and only one can be selected at a time.
2. Press the SCENE button to play a scene from the selected bank. If there are no scenes programmed in a bank, they cannot be played.
3. Scenes can run automatically, and their duration depends on the tempo tapped by TAP SYNC. Scenes can also be executed under music or NOTE triggering.
By following these steps, you can easily program and play scenes on the AUDIBAX Control 8 192 Channel DMX Controller as per the user manual instructions.
Add New Comment