User Manual Q&AAnswer
Aug 12, 2025 - 12:13 AM
To get started with the YAHBOOM Sensor Kit for Microbit, follow these steps as outlined in the user manual:
1. Servo Calibration:
- Download the hex file provided in the manual for servo calibration from the tutorial link provided.
- Complete the calibration of the servo by following the instructions in the manual.
2. Assembling Building Blocks:
- Assemble the building blocks according to the steps provided in the manual.
3. Connecting Sensor Modules:
- Connect the sensor modules to the expansion board according to the wiring diagram provided in the manual.
4. Programming Micro:bit:
- Download the hex file provided for a specific course to the Micro:bit board using the USB data cable.
5. Viewing Experimental Phenomena:
- Observe the experimental results based on the program downloaded to the Micro:bit board.
Tips for Successful Usage:
- Use a dual-head micro USB data cable to connect the computer, board, and expansion board for servo operation.
- Download the servo calibration code before assembling to avoid servo jamming and damage.
- Pay attention to the servo installation direction to prevent issues with servo movement.
- Follow safety instructions provided in the manual to ensure safe usage of the product.
Remember to refer to the tutorial link provided in the manual for detailed instructions and troubleshooting tips. If you encounter any difficulties during setup or usage, you can reach out to Yahboom's technical support via WhatsApp or email for assistance.
For further information and detailed instructions, please refer to the official YAHBOOM Sensor Kit for Microbit user manual available at [Yahboom Sensor Kit Manual](https://www.yahboom.com/study/WOM-Sen...).
Add New Comment