User Manual Q&AAnswer
Aug 10, 2025 - 11:51 PM
According to the EMOS P5733W Wireless Doorchime Instruction Manual, you can pair additional buttons with the chime by following these steps:
1. Remove the rear cover of the new button by inserting a screwdriver into the hole on the bottom.
2. Insert a 3 V type CR2032 battery into the button, ensuring correct polarity. Replace the battery cover.
3. Plug the chime unit into a 230 V AC/50 Hz socket.
4. Long-press the volume button on the chime for approximately 5 seconds. The chime LED will light up; release the button.
5. The chime will enter self-learning pairing mode for 30 seconds. During this time, press the ring button on the new button. The chime will ring, indicating successful pairing.
6. This process automatically ends self-learning mode for that button.
7. To pair multiple buttons, repeat the above steps for each additional button.
It is important to note that the chime has a memory to store the codes of paired buttons, so there is no need to re-pair buttons after a power cut. If you want to change the ringtone of already paired buttons, you must first wipe the memory of paired buttons by following the instructions provided in the manual.
Add New Comment