User Manual Q&AAnswer
Aug 08, 2025 - 06:02 AM
To change the high-frequency unit on your TW AUDiO VERA36 loudspeaker for different coverage options, follow these steps as outlined in the user manual:
1. Place the VERA36 loudspeaker on its back with the front grill facing up on a clean, non-slip surface.
2. Ask for assistance to secure the speaker against lifting and slipping.
3. Remove the four grill mounting screws located on the left and right sides of the speaker enclosure using a TX25 hexalobular key.
4. Carefully unplug the connector from the high-frequency unit.
5. Loosen the two screws of the high-frequency unit using a tool with SW8.
6. Carefully pull the high-frequency unit upward out of the loudspeaker enclosure.
7. Guide the new high-frequency unit into the guide groove until it hits the rear and xxxx it onto the enclosure.
8. Reconnect the high-frequency unit into the connection plate.
9. xxxx on the front grill.
10. Change the marking for the installed high-frequency unit on the rear rigging to reflect the new variant.
Following these steps will allow you to change the high-frequency unit on your TW AUDiO VERA36 loudspeaker to adjust the horizontal coverage as needed. Remember to refer to the manual for detailed illustrations and additional information.
Add New Comment