User Manual Q&AAnswer
Aug 04, 2025 - 12:42 AM
To program multiple on/off cycles for different days of the week using the amerec I24-7 Optional 120V Digital Clock for AI Boiler, follow these steps:
1. Setting the Time of Day:
- Slide the RUN switch to the current day.
- Press the 1...7 button to select the weekday.
- Press the h button to set the hours and the m button to set the minutes.
- Slide the RUN switch back to RUN.
2. Programming an ON/OFF cycle:
- Slide the RUN switch to P.
- Setting each cycle to "switch on":
- Press the h and m buttons to set the switch-on time.
- Press the 1...7 button to select the day(s) for this ON cycle to occur.
- Press the P button to save the on cycle setting and proceed to the off cycle setting.
- Setting each cycle to "switch off":
- Press the h and m buttons to set the switch-off time.
- Press the 1...7 button to select the day(s) for this OFF cycle to occur.
- Press the P button to save the off cycle setting and move to the next on cycle setting.
- Repeat the above steps to program up to 8 on/off cycles (16 switch points) in any 24-hour period.
3. Automatic Operation:
- Set the slide switches to RUN and AUTO for the load to be turned on or off according to the programmed switch times.
4. Manual Operation:
- Slide the AUTO I switch to turn the load on.
- Slide the AUTO O switch to turn the load off.
5. Skip Cycle:
- While in AUTO and RUN mode, pressing the skip button can temporarily override a programmed on or off point.
6. Clear/Reset All:
- Press the R button to clear all programmed switch settings and the time and day.
By following these steps outlined in the manual, you can efficiently program multiple on/off cycles for different days of the week using the amerec I24-7 Optional 120V Digital Clock for AI Boiler.
Add New Comment