User Manual Q&AAnswer
Aug 03, 2025 - 10:38 PM
To connect the Armacost LIGHTING 714421 ProLine WiFi RGB plus with Color LED Controller to your LED lighting, follow these steps as outlined in the user guide:
1. Input – from power supply:
- Ensure the LED lighting voltage is within the 6–24 volts DC range and below the rated wattage of the power supply.
- Connect the input wires from the power supply to the controller as indicated by the polarity markings on the controller (+ to + and – to –).
2. Output – to LED lighting:
- Observe the polarity indicated on the controller when connecting to LED lighting (+ to +, G to G, R to R, B to B, and W to W).
- Make sure the voltage of the LED lighting matches the power supply and does not exceed the maximum load of the controller.
3. Controller status indicator:
- Pay attention to the status indicator light on the controller to ensure proper functioning and to identify any issues that may arise during operation.
4. Wiring diagram:
- Connect the power supply to the controller input and the controller output to the LED lighting.
- Ensure all power cables are securely connected and insulated before powering on the system.
By following these steps and guidelines provided in the user guide, you can safely and effectively connect the Armacost LIGHTING 714421 ProLine WiFi RGB plus with Color LED Controller to your LED lighting setup. If you encounter any difficulties or have further questions, you can refer to the user guide or contact Armacost Lighting customer support for assistance.
Add New Comment