User Manual Q&AAnswer
Aug 02, 2025 - 05:08 AM
To set up the wireless control feature using Wifly on the ADJ Encore Z7LP LED Par Fixture Light, follow these steps:
1. Enable Wifly:
- Access the system menu on the fixture's control panel display.
- Navigate to the "Wifly Settings" option.
- Set Wifly Enable to ON.
2. Set Wifly Channel:
- In the system menu, find the "Set Wifly channel" option.
- Adjust the channel setting to a value between 00 and 14.
3. Check Wifly Connection:
- Once Wifly is enabled and connected, a signal strength bar should display on the control panel.
- A green LED indicator will light up to indicate that Wifly is connected.
4. Wireless Setup Tips:
- Install the fixture at least 9.8 ft (3m) above audiences or ground level for optimal wireless signal reception.
- Position the wireless antenna in an upright, vertical position.
- Ensure direct line of sight between the fixture and the transmitting controller for better signal reception.
By following these steps, you can successfully enable and configure Wifly for wireless control on the ADJ Encore Z7LP LED Par Fixture Light.
Add New Comment