User Manual Q&AAnswer
Jul 29, 2025 - 05:37 AM
To set the DMX start address for the SNAP Lighting Control Panel, follow these steps as outlined in the instruction manual:
1. Press any button to awaken the interface.
2. Use the Up/Down buttons to select the parameter to configure. The Address LED indicator should be lit.
3. Press and hold the Enter button. Dots will flash at the bottom of one of the 7-segment screens.
4. Use the Up/Down buttons to select the desired DMX start channel.
5. Press Enter to accept the changes or Esc to discard them.
6. The valid range for the DMX start address is 1 through 512. The practical maximum is 497 for 16 relays or 505 for 8 relays.
7. Setting a start address will clear a soft patch if one is in use.
By following these steps, you can successfully configure the DMX start address for the SNAP Lighting Control Panel.
Add New Comment