User Manual Q&AAnswer
Jul 28, 2025 - 01:15 AM
If your Hama 00186383 Radio-Controlled DCF Wall Clock is unable to receive the DCF signal for automatic time setting, you can manually set the time by following these steps as per the instruction manual:
1. Press and hold the UP button and the DOWN button simultaneously for approximately 3 seconds to stop the search for the DCF signal. The wireless icon will disappear, indicating that you can now set the time manually.
2. Press and hold the MODE button for about 3 seconds to enter the manual setting mode. You can then set the hours, minutes, year, month, and day one after the other by pressing the UP or DOWN buttons to adjust the values and confirming each selection by pressing the MODE button.
3. While setting the minutes or seconds, you can press the °F/°C button to switch between the 12-hour (a.m./p.m.) and 24-hour formats.
4. If you do not make an entry for 10 seconds, the clock will automatically exit the setup mode.
5. To select the language for the day of the week display, hold down the DOWN button until the desired language appears.
By following these steps, you can manually set the time on your wall clock when it is unable to receive the DCF signal for automatic synchronization.
Add New Comment