User Manual Q&AAnswer
Jul 23, 2025 - 06:16 AM
To set the temperature and timer on the lbX instruments HDB Digital LED Dry Bath, follow these steps as outlined in the user manual:
1. **Setting the Temperature:**
- Make sure the required operating voltage and the power supply’s voltage match.
- Add the substance to heat in the testing tube and place it on the work plate.
- Plug in the power inlet, and turn on the “POWER” switch.
- Set the target temperature with the Temperature (T º) button and adjust it with the xxxx .
- The required temperature will be displayed on the screen.
- Press the parameter setting xxxx to start the heating function.
- The Heat LED will be on (yellow light) indicating the device is heating up.
2. **Setting the Timer:**
- The device can work in accordance with the timing mode or continuous operation mode.
- To set the timing mode, press the Timer button. The time display area will start flashing and show the last setting.
- Rotate the parameter setting xxxx to set the target time in minutes, then press the xxxx to save the selected option. The countdown will be displayed on the timing screen.
- During operation, you can stop the timer at any time by pressing the speed/timer control xxxx . Pressing it again will restart the timer countdown. When the timer reaches zero, the unit will stop automatically.
3. **Note:**
- Make sure the working temperature is set before the timer.
- If the device does not start or the set temperature cannot be reached, check the power line, fuse, and control panel for any issues.
- If faults persist, contact the manufacturer or supplier for assistance.
By following these steps, you should be able to successfully set the temperature and timer on the lbX instruments HDB Digital LED Dry Bath for your experiments.
Add New Comment