User Manual Q&AAnswer
Jul 21, 2025 - 07:20 AM
To configure the Novus N1040T Temperature Controller to work with a Pt100 sensor, follow these steps:
1. Access the "INPUT" cycle on the controller.
2. Select "Type" parameter.
3. Choose "Pt" for Pt100 sensor from the available options (J, K, T, Pt100).
4. Ensure the correct wiring of the Pt100 sensor to the controller's input terminals.
5. Adjust the "Filter" parameter if needed to improve signal stability.
6. Validate the configuration by checking the display for the measured variable (PV) to ensure it corresponds to the Pt100 sensor readings.
By following these steps and referring to the user manual for detailed instructions, you can successfully configure the Novus N1040T Temperature Controller to work with a Pt100 sensor.
Add New Comment