User Manual Q&AAnswer
Jun 22, 2025 - 10:50 AM
To pair the LED wireless dimmer with the remote control, follow these steps:
1. **Pairing Operation Instructions:**
- Step 1: Connect the light to the controller, and press and hold the "SET button" on the remote control before powering on the controller.
- Step 2: Power on the controller. The load outputs 50% brightness, indicating it's in the code matching state.
- Step 3: Press the middle "mode button" three times continuously. The load will output 25% brightness, 10% brightness, and return to the light state before the last power failure, flashing three times to indicate the completion of the code.
If the code matching is unsuccessful, repeat the above steps, ensuring each step is completed within 3 seconds after the previous step.
**Note:** After pairing, the receiver will only be controlled by the current remote control.
**Instructions for Clearing Code:**
1. Step 1: Connect the light to the controller, and press and hold the "SET button" on the remote control before powering on the controller.
2. Step 2: Power on the controller. The load outputs 50% brightness, indicating it's in the clear code state.
3. Step 3: Press the "Delay button" three times continuously. The load will output 25% brightness, 10% brightness, and return to the light state before the last power failure, flashing three times to indicate the code clearing.
If the code clearing is unsuccessful, repeat the above steps, ensuring each step is completed within 3 seconds after the previous step.
**Note:** Any remote control of the same model can clear the code of the receiver. After clearing the code, the receiver can be controlled by any remote control with a different code value.
Add New Comment