User Manual Q&AAnswer
May 28, 2025 - 06:14 AM
To change the threshold values for a faultless diode (green color of the screen) and a faulty one (red color of the screen) on the MS021 Diode Bridges Tester, follow these steps as outlined in the user manual:
1. **Enter the Settings Menu:**
- Turn off the device.
- Press and hold down the encoder button (Button "3" on the device) and keep it pressed.
- Turn the device on. This will activate the setup mode.
2. **Adjust Threshold Values:**
- In the setup mode, you can change the threshold values for a faultless diode and a faulty one by turning the encoder button clockwise or counterclockwise.
3. **Save Settings:**
- Once you have adjusted the threshold values to your preference, press and hold down the encoder button until the device exits the setup mode and the message "CONNECT PROBE TO DIODE" appears on the screen. This will save your selected settings.
4. **Exit Setup Menu:**
- Turn off the tester to exit the setup menu. If you do not turn off the device, the settings will not be saved.
By following these steps, you can customize the threshold values on the MS021 Diode Bridges Tester to suit your specific requirements for diagnosing diodes effectively.
Add New Comment