User Manual Q&AAnswer
May 26, 2025 - 10:43 AM
According to the instruction manual for THE HOME DEPOT MVGCZKH I-Shaped Sliding Barn Door Track and Hardware Kit, here are the steps to determine the correct height for installing the rail and door stoppers:
1. **Marking the Height:**
- Place the rail against the wall and use a pencil to mark where the holes should be drilled. Ensure that the height of the holes on the wall is H+1h6".
2. **Installing Door Stoppers:**
- Insert door stoppers into the rail and install them between points A-B and C-D. Door stoppers are essential for preventing the hangers from coming out of the rail.
3. **Creating a Kerf for Floor Guide:**
- Use a router or circular saw to create a kerf at the bottom of the door, along the center, to allow the tip of the T-shaped floor guide to fit in between. This helps keep the door stable and prevents swinging when sliding it open and closed.
4. **Installing Hangers on the Door:**
- Follow the provided measurements to install the hangers onto the door. Ensure the maximum door thickness is 1 3/4" and adjust the door bolts accordingly.
5. **Installing Rubber Ends:**
- Drill holes on the door top side, 1/2" away from the edge, and install the rubber ends to protect the door from touching the rail during sliding.
6. **Hanging the Door:**
- Hang the door over the rail and turn the rubber ends approximately 180 degrees to secure them between the door and the rail.
7. **Adjusting Door Stoppers:**
- Adjust the two door stoppers to find a suitable position and use a hex key to xxxx them in place securely.
8. **Installing Floor Guide:**
- Place the floor guide on the floor to determine a suitable position. Make a mark for drilling holes so that the tip of the floor guide aligns well in the slot. Drill holes on the floor and install the floor guide accordingly.
By following these steps and measurements provided in the manual, you can accurately determine the height for installing the rail and door stoppers in THE HOME DEPOT MVGCZKH I-Shaped Sliding Barn Door Track and Hardware Kit.
Add New Comment