User Manual Q&AAnswers
May 26, 2025 - 06:12 AM
To match the remote control to the LED strip controller, you have two options as outlined in the manual:
**Option 1: Using the Controller's Match Key:**
- Press the Match key on the controller.
- Immediately press the On/Off key (for a single-zone remote) or the Zone key (for a multiple-zone remote) on the remote to pair them.
- To delete all matches, press and hold the Match key for 5 seconds. The light will blink 5 times to indicate that all matched remotes have been deleted.
**Option 2: Using Power Restart:**
- Switch off the power to the LED strip controller and then switch it back on.
- Repeat the power cycle.
- Immediately press the On/Off key on the remote three times. The light will blink three times to indicate a successful match.
- To delete all matches using this method, repeat the power cycle and then press the On/Off key on the remote five times. The light will blink five times to confirm that all matched remotes have been deleted.
Following these steps will ensure that your remote control is successfully matched to the LED strip controller, allowing you to control your RGBW LED lights effectively.
May 26, 2025 - 09:57 AM
To match the remote control to the LED strip controller, you have two options as outlined in the manual:
**Option 1: Using the Controller's Match Key:**
- Press the Match key on the controller.
- Immediately press the On/Off key (for a single-zone remote) or the Zone key (for a multiple-zone remote) on the remote to pair them.
- To delete all matches, press and hold the Match key for 5 seconds. The light will blink 5 times to indicate that all matched remotes have been deleted.
**Option 2: Using Power Restart:**
- Switch off the power to the LED strip controller and then switch it back on.
- Repeat the power cycle.
- Immediately press the On/Off key on the remote three times. The light will blink three times to indicate a successful match.
- To delete all matches using this method, repeat the power cycle and then press the On/Off key on the remote five times. The light will blink five times to confirm that all matched remotes have been deleted.
Following these steps will ensure that your remote control is successfully matched to the LED strip controller, allowing you to control your RGBW LED lights effectively.
Add New Comment