User Manual Q&AAnswer
May 03, 2025 - 03:50 AM
To connect the to an Arduino, you will need the following components:
- 2x Arduino UNO
- 2x VMA348 RFM69HCW module
- 1x VMA320 analogue temperature sensor module
- 20x jumper wire
- 2x USB-A to USB-B cable
Here are the steps to connect the VMA348 module to the Arduino:
1. Connect the VMA348 module to the Arduino as depicted in the manual. Make sure to connect one temperature sensor to one Arduino.
2. Download the RadioHead library from the provided link and add it to the Arduino IDE.
3. Go to GitHub and download both codes provided in the manual.
4. Open the RF69_CLIENT_SEND_DATA code and upload it to the Arduino with the temperature sensor. You should see the output as mentioned in the manual.
5. Open a new IDE with the RF69_SERVER_RECEIVE_DATA code and upload it to the Arduino without the temperature sensor. You should see the output as mentioned in the manual.
Following these steps will allow you to connect the Velleman VMA348 Transceiver Breakout Board to an Arduino and send data between the modules. For more detailed instructions and code examples, please refer to the manual provided.
Add New Comment