User Manual Q&AAnswer
May 03, 2025 - 03:44 AM
To connect the Velleman VMA337 Time-Of-Flight Ranging and Gesture Detection Sensor to an Arduino Uno, you will need to make the following connections:
1. Connect the GND pin of the VMA337 to the GND pin of the Arduino Uno.
2. Connect the Vin pin of the VMA337 to the 5V pin of the Arduino Uno.
3. Connect the SDA pin of the VMA337 to the A4 (SDA) pin of the Arduino Uno.
4. Connect the SCL pin of the VMA337 to the A5 (SCL) pin of the Arduino Uno.
Please note that the Y and G connections on the VMA337 (XSHUT and GPIO1) are not used in this example. Refer to the VL53L0X data sheet for more information on these connections.
For more information and detailed instructions, please refer to the Velleman VMA337 Time-Of-Flight Ranging and Gesture Detection Sensor User Manual.
Add New Comment