User Manual Q&AAnswer
May 03, 2025 - 12:45 AM
When installing and using the COMMSCOPE CAPL2CBAND Extension Unit, it is important to follow the health and safety precautions outlined in the instruction manual. Some of the key precautions include:
1. Wet conditions: Never install or use electrical equipment in a wet location or during a lightning storm to prevent electrical shock.
2. RF energy: The CAP L2 continuously emits RF energy, so it is important to maintain a minimum clearance from the antenna while the system is operating. Power down the CAP L2 before servicing the antenna whenever possible.
3. Connector caps: Do not remove caps from any of the connectors until instructed to do so.
4. Use with approved equipment: The CAP L2 should only be used with CommScope (NEC Class 2) or Limited Power Source ERA Subrack, or equivalent.
5. License holders: Only license holders for the respective frequency range are allowed to operate the unit.
6. Warning labels: Read and obey all warning labels attached to the unit. Replace any missing or damaged labels.
7. Correct settings: Ensure that the unit's settings are correct for the intended use and meet regulatory requirements. Do not carry out any modifications or fit any spare parts not sold or recommended by the manufacturer.
These are just a few examples of the health and safety precautions to be followed. For a comprehensive understanding, please refer to the instruction manual provided with the .
Add New Comment