How do I connect the OSRAM Proximity Sensor Module to my computer? (OSRAM ‎ Proximity Sensor Module User Guide)

Answer

manuals.plus

Apr 14, 2025 - 08:18 AM

To connect the OSRAM TMD2621 Proximity Sensor Module to your computer, you will need the following components: TMD2621 Daughter Card, EVM Controller Board, USB Cable (A to Micro-B), and a Flash Drive.

1. Install the software: Before connecting any hardware, install the software by following the instructions in the Quick Start Guide. This will load the required driver for the USB interface and the device's graphical user interface (GUI).

2. Connect the hardware: Connect the TMD2621 Daughter Card to the EVM Controller Board using the seven-pin connector. Then, connect the EVM Controller Board to your computer using the USB Cable.

3. Verify the connection: When the EVM Controller Board is connected to the USB, a green LED will light up to indicate that the system is receiving power. If the LED does not light up, check the USB connection and make sure it is properly connected.

4. Start the software: The software should automatically connect to the hardware on startup. If it detects any errors, an error window will appear. If the software displays "Device not found or is unsupported," make sure the correct daughterboard is connected to the EVM Controller Board. If it displays "Cannot connect to EVM board," verify that the USB cable is properly connected.

Once the software is connected to the hardware, you can use the GUI to control and monitor the OSRAM TMD2621 Proximity Sensor Module. Refer to the user guide and datasheet for more detailed information on using the software and configuring the sensor module.

Note: The above instructions are a summary based on the provided user guide. For complete and accurate instructions, please refer to the OSRAM TMD2621 Proximity Sensor Module User Guide.