How do I install the ELCO Lighting ELK4714W 4 Inch Unique Square Reflector for Koto Module?
To install the ELCO Lighting ELK4714W 4 Inch Unique Square Reflector for Koto Module, follow these steps:
1. Ensure that the power to the lighting fixture is turned off before beginning the installation process.
2. Remove the existing trim or module from the housing, if applicable.
3. Take the ELK4714W reflector and align it with the Koto LED Module. The reflector has a twist-lock design, so you will need to rotate it until it locks into place securely.
4. Once the reflector is locked in place, use the provided clips to mount the trim into the housing. This will keep the ring flush with the ceiling.
5. Make sure that the reflector is properly aligned and securely attached to the Koto LED Module.
6. Turn on the power and test the lighting fixture to ensure it is functioning correctly.
Please note that the ELK4714W reflector is recommended for use with New Construction Housings only. It is also important to refer to the specific instructions and guidelines provided by ELCO Lighting for your particular installation scenario.
For further assistance or troubleshooting, please consult the ELCO Lighting ELK4714W product manual or contact ELCO Lighting customer support.
Answer this question
Answers are reviewed before publication.