How do I set the alarm on the Jensen QiCR-200 Dual Alarm Clock Radio?
I want to set the alarm on my Jensen QiCR-200 Dual Alarm Clock Radio but I'm not sure how to do it. Can you provide step-by-step instructions?
To set the alarm on the Jensen QiCR-200 Dual Alarm Clock Radio, follow these steps:
1. Make sure the clock is in standby mode. If the display is not flashing, press and hold the / MEM / M + BUTTON (#1) until the clock display begins to flash.
2. Press and hold the / BUTTON (#7) to enter the ALARM 1 time setting mode. The alarm time display will flash.
3. Tap the HOUR/ BUTTON (#2) repeatedly to set the alarm hour. Press and hold the button to increase the time faster.
4. After setting the hour, tap the MIN/ BUTTON (#3) repeatedly to set the alarm minutes. Press and hold the button to increase the time faster.
5. Tap the / BUTTON (#7) to confirm the alarm time.
6. Follow the same steps to set ALARM 2 using the / BUTTON (#8).
7. To select the wake-up mode for each alarm, tap the / BUTTON (#7) repeatedly for ALARM 1 or the / BUTTON (#8) for ALARM 2. The corresponding alarm indicators will light up to indicate the selected mode.
8. To wake up to an alarm, make sure the ALARM 1 INDICATOR (wake to an alarm) (#11) or ALARM 2 INDICATOR (wake to an alarm) (#13) is lit. To wake up to the radio, make sure the ALARM 1 INDICATOR (wake to a radio) (#12) or ALARM 2 INDICATOR (wake to a radio) (#14) is lit. To turn off the alarm, make sure both WAKE to ALARM & RADIO indicators are off.
9. When the alarm sounds, you can use the SNOOZE BUTTON (#5) to temporarily turn off the alarm and activate the snooze function. The alarm will sound again 9 minutes later. To cancel the snooze period and the alarm, press the / MODE BUTTON (#9).
Note: If ALARM 1 and ALARM 2 are set to the same time, only ALARM 1 will sound.
Answer this question
Answers are reviewed before publication.