PWNAGE-LOGO

PWNAGE StormBreaker Max CF Gaming Mouse

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-PRODUCT

WHAT’S IN THE BOX

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-1FUNCTION LAYOUT

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-2

  • A. Left mouse button
  • B. Scroll wheel
  • C. Right mouse button
  • D. Forward button
  • E. Back button
  • F. USB Type-C port
  • G. PTFE mouse feet
  • H. Pwnage adjustable sensor
  • I ON/OFF Switch

COMBINED FUNCTION KEYS

The DPI stages are:
400 Red/ 800 Green/ 1600 (default) Dart blue/ 3200 Orange/ 6400 Yellow

To cycle through the DPI stages
Press at the same time E + B + C and hold pressed down for 3 Seconds
After switching to the corresponding DPI setting, there will be a corresponding indicator light (the color can be adjusted in the software)

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-3

The Polling Rate modes are:
125Hz / 250Hz / 500Hz / I000Hz (default) / 2000Hz / 4000Hz / B000Hz

To cycle the polling rate
Press at the same time A+ B + C and hold pressed down for 3 Seconds
The light flashes once, which means the switch is successful

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-4

The Lift Off Distance (LOO) settings are:
lmm(default) / 2mm

To adjust the LOD
Press at the same time D + B + A and hold pressed down for 3 Seconds
The yellow light flashes once, which means the switching is successful

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-5

SENSOR POSITION CUSTOMIZATION

  1. Loosen the screws sllghtly with the screw driver
  2. Use the screw driver to move the screws up and down to adjust the sensor position
  3. Tighten the screw after moving the sensor to your desired position.PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-6

CONNECTING YOUR STORMBREAKER

  • A. Via Wired ModePWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-7
  • B. Via Pwnage HyperSpeed Pyramid Wireless (2.4GHz) Mode PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-8
  • Pyramid will flash a red LED light when connecting. When connected to the mouse, the pyramid will have a solid white LED light
  • For optimal wireless performance, place pyramid within 12″-24″ of the mouse and away from sources of 2.4GHz such as wi-fi routers.

Mouse Sleep Settings

Further customization is available via StormBreaker Software

Defaults

  • Level 1 Sleep: If no movement or press is detected, the mouse enters the first level sleep mode after 30 seconds (default). Wake up by any movement or any key press.
  • Level 2 Sleep: If no movement or press is detected after 5 minutes, the mouse enters the secondary sleep mode. The 2.4GHz is disconnected and the Sensor LED is turned off. Wake up by pressing any key.

Low Power Alert and Charging Display

In wireless mode, the mouse light indicator will flash red 3 times every 5 seconds when the battery is low. The red flashing stops when the mouse enters a sleep mode.
To charge the mouse, disconnect the provided cable from the HyperSpeed pyramid receiver and plug it into the mouse. When charging, the mouse light indicator will remain a solid red color. The red light indicator will turn off when the mouse is fully charged.

PWNAGE-StormBreaker-Max-CF-Gaming-Mouse-FIG-9

SAFETY GUIDELINES

  1. Do not expose the gaming mouse to liquid, extreme temperatures, humidity, dust, or direct sunlight.
  2. Do not attempt to disassemble or modify the gaming mouse.
  3. Do not attempt to clean the gaming mouse with any liquids or chemicals.
  4. Do not use the gaming mouse if it is damaged or malfunctioning.
  5. Do not use the gaming mouse if the Li-ion battery is damaged or leaking.
  6. Do not insert any foreign objects into any of the mouse openings

MAINTENANCE GUIDELINES

  1. Ensure the gaming mouse is powered off before cleaning.
  2. Use a damp cloth to gently wipe the surface of the gaming mouse to remove any dirt or dust.
  3. Store the gaming mouse in a cool, dry place when not in use.
  4. Use compressed air duster to blow out and remove dust & debris from hard-to-reach areas inside the mouse

RF Warning Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference
  2. This device must accept any interference received, including interference that may cause undesired operation

Warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction

Copyright

© 2024 Pwn□ge, LLC. All rights reserved. Pwnage and Pwnage logo are trademarks or registered trademarks of Pwnage, LLC in the United States or other countries. All other trademarks are the property of their respective owners.

Limited Product Warranty

For the latest and current terms of the Limited Product Warranty, please visit www.pwnage.com

Limitation of Liability
Pwnage shall in no event be liable for any lost profits, loss of information or data, special, incidental, indirect, punitive or consequential or incidental damages arising in any way out of the distribution of, sale of, resale of, use of, or inability to use the product

General
These terms shall be governed by and construed under the laws of the jurisdiction in which the Product was purchased. If any term herein is held to be invalid or unenforceable, then such term (in so far as it is invalid or unenforceable) shall be given no effect and deemed to be excluded without invalidating any of the remaining terms. Pwnage reserves the right to amend any term at any time without notice.

Documents / Resources

PWNAGE StormBreaker Max CF Gaming Mouse [pdf] User Manual
StormBreaker Max CF Gaming Mouse, Max CF Gaming Mouse, CF Gaming Mouse, Gaming Mouse, Mouse

References

Leave a comment

Your email address will not be published. Required fields are marked *